Tolono, IL

Repaired a pinhole water leak near the water heater by removing the damaged pipe section and 90-degree fitting. Installed two new couplings and a replacement 90-degree elbow to eliminate leaking pipes and ensure a lasting plumbing repair.

Performed HVAC maintenance and plumbing inspection. Verified plumbing had no issues and completed furnace repair by replacing a faulty draft inducer motor to restore safe, efficient heating.

Inspected flange and reset toilet with a new wax ring, supply line, bolts, and caps to resolve base leak. Replaced three toilet shut-off valves, restored water supply, and tested all connections to ensure leak-free plumbing repair.

Replaced air filter, cleaned furnace burners, flame sensor, and condensate trap, and checked airflow pressures. Tested sump pump, inspected plumbing, and diagnosed a kitchen sink leak, providing options for plumbing repair and replacement.

Cleaned furnace burners and flame sensor, tested igniter, flue pressure, and blower/inducer motor amperages. Replaced a low 25 µF capacitor to maintain system reliability during routine HVAC maintenance.

Cleaned and inspected heating components for HVAC maintenance. Conducted plumbing checks: dye-tested toilets, verified water pressure and temperature, checked shutoff valves, and completed a sewer line camera inspection.

Cleaned and inspected furnace components during routine HVAC maintenance. Performed plumbing checks: tested water pressure, inspected toilet/sink shut-off valves, ran toilet dye tests, and verified kitchen sink connection was secure.

Diagnosed a lack of hot water affecting half the building. Located closed shutoff valves on the electric water heater and opened the inlet, outlet, and recirculating pump valves to restore hot water flow to all fixtures.

Replaced a malfunctioning thermostat with a user-friendly Honeywell Focuspro P200. Tested and verified proper operation of both the heating and cooling systems.

Diagnosed mini-split AC not cooling due to low refrigerant. Scheduled a system recovery and precise weigh-in of a new R-410A refrigerant charge to restore proper cooling.

Replaced a failed capacitor and corrected a blower wiring issue by connecting the Y wire to the terminal. This restored proper airflow and resolved the AC not cooling issue, returning the system to normal operation.

Warranty service visit for a noisy air conditioner was canceled prior to technician dispatch. No HVAC maintenance or repairs were performed.

Completed air conditioner repair for units not cooling. Diagnosed refrigerant leaks and replaced the evaporator coils on both systems, recharging them with refrigerant to restore proper cooling and efficiency.

Sealed a disconnected main duct trunk at the furnace plenum that was leaking air into the crawlspace. Verified correct refrigerant charge and system operation to restore effective cooling and lower humidity.

Replaced bathroom plumbing shower valve with a new Delta kit and copper piping. Also installed a new Liberty 237 sump pump with a check valve and platform. Tested both systems to ensure leak-free, proper operation.

Investigated sewer backup by rodding sewer line. Encountered persistent mud obstruction at 15 feet. Located the damaged, collapsed pipe section behind the shed at 2'2" depth to determine the exact area needed for sewer line repair.

Inspected leaking shower faucet and provided quotes for shower valve replacement and sump pump replacement. Scheduled return visit next Tuesday to perform the plumbing repair and replace the shower valve.

Flushed the water heater, inspected drains, and tested the sump pump. Completed HVAC maintenance by cleaning cooling components and replacing a failing capacitor to restore optimal AC performance.

Completed HVAC maintenance and plumbing inspection. Replaced filter, cleaned outdoor coil, and tested the sump pump. Diagnosed high superheat and low subcooling; recommended a refrigerant leak detection test to address low levels.

Resolved a frozen coil by replacing a stuck contactor that caused the AC system to freeze and leak water. Added UV dye to monitor for potential refrigerant leaks and verified proper, efficient cooling.

Bi-annual HVAC maintenance: tested the capacitor and contactor, blew out and treated the condensate drain with tabs, secured electrical connections, and verified the delta T is within the optimal range for efficient cooling.

Washed the outdoor condenser coil and cleared the condensate drain line for routine HVAC maintenance. Inspected electrical wire connections and verified the temperature difference (Delta T) is within the optimal range for efficient cooling.

Flushed AC condensate line, replaced air filter, and cleaned outdoor coils during HVAC maintenance. Checked electrical components and refrigerant. Also inspected drains and verified sump pump operation, noting a tripped breaker issue.

Installed a Storm Cell battery backup system and a new Liberty 237 1/3hp sump pump with a new check valve, platform, and piping. Tested and verified backup system operation to ensure reliable basement waterproofing.

Resolved a clogged condensation drain by performing drain cleaning. Rodded the line 30 feet with a 5/16 cable to clear sludge blockage. Furnace proximity limited water testing, but the drain is now functioning properly.