Mahomet, IL

Restored cooling by replacing a congested 16x25x1 filter and a weak 45/5 capacitor (reading 34/3.5). This AC repair improves efficiency, though extremely hot weather may make it difficult to reach low thermostat setpoints like 68 degrees.

Diagnosed water heater with no hot water. Confirmed burner, flue, and gas valve are operational. Identified a faulty pressure switch with low continuity. A return visit is required to replace the pressure switch and restore hot water.

Inspected blocked sump pump discharge line with a camera. Found pipe pinched shut 10ft from driveway and 1ft from basement. Attempted cable clearing without success. Located line exit and provided a quote for full pipe replacement.

Performed clogged drain repair on a slow bathtub. Removed the stopper and cleared a significant hair buildup obstructing the line. Filled and emptied the tub to test and verify proper, efficient drainage.

Inspected air conditioner following reported condenser failure. Found the system operating normally upon arrival and advised the customer on the challenges of diagnosing intermittent HVAC issues while the unit is currently functioning.

Replaced failed Lennox AC capacitor, contactor, and hard start kit during HVAC maintenance. Changed filters. Inspected plumbing, checked water pressure, and diagnosed a corroded water heater dielectric union.

Cleaned outdoor AC unit, tested capacitor, and verified Delta T. Inspected plumbing drains and sinks, and completed toilet dye tests. Note: Water heater is too old to service; glued AC condensate line trap is currently inaccessible.

Replaced 16x25x5 HVAC filter; tested airflow, electricals, and refrigerant. Performed toilet dye tests and valve checks. Noted water pooling in the crawlspace near the shut-off valve, alerted homeowner, and quoted outdoor spigot replacements.

Diagnosed an AC not cooling issue caused by an outdoor fan not spinning. Replaced the failed dual-run capacitor to restore proper fan operation and ensure efficient cooling.

Replaced filter, cleared the condensate line using a Swoosh device and solution, and verified static pressures, capacitors, Delta T, and blower motor amperages on both units to ensure peak system efficiency and HVAC maintenance.

Inspected, cleaned, and tested a package geothermal system during cooling HVAC maintenance. Verified proper heat rejection, leaving the unit running efficiently at over 90% of its full operating capacity.

Conducted follow-up heating and cooling service. Verified furnace gas pressure (1.6/3.44 inWC) and airflow. Tested 3-ton AC refrigerant charge (125/360 psi), superheat (24), and subcooling (10) to confirm optimal HVAC system performance.

Completed Service Titan software training to streamline dispatching, scheduling, and client communication for future HVAC repair and maintenance calls.

Reset a tripped breaker to restore 240V power to the condenser and replaced a faulty capacitor. Verified proper system performance with a 16°F temperature split to ensure reliable cooling.

Resolved clogged refrigerator water line with a plumbing repair. Replaced the old hose and fitting with a new braided hose to restore proper water flow. Inspected the upstairs bathtub drain and discussed future upgrade options.

Wired the upflow system humidifier to the 850 Comfort Control to resolve high humidity issues. Scheduled follow-up to wire the second downflow humidifier to the same control for improved indoor air quality.

Completed HVAC maintenance and plumbing inspection. Washed AC condenser, flushed condensate drain, and tested electrical components. Dye-tested toilets, checked traps, and verified sump pump and backup pump operation.

Conducted water leak detection. Found no active plumbing leaks; traced the basement moisture to liquid runoff on the first-floor bathroom floor traveling down the floor vent and leaking into the mechanical room below.

Diagnosed a toilet tank-to-bowl leak and failing garbage disposal motor. Flushed the water heater and inspected the sump pump to ensure proper home plumbing system performance and safety.

Secured a loose electrical disconnect box to structural framing instead of just the siding, restoring a safe and stable connection to the home's outdoor air conditioner.

Completed an air conditioning installation by mounting and connecting a new outdoor condenser unit, optimizing home comfort and energy-efficient cooling performance.

Resolved a mini-split issue where one indoor head shut off after a few minutes. Replaced both indoor circuit boards on the faulty unit to restore proper cooling and reliable air conditioner operation.

Replaced a deformed flush tower seal that was causing water to run continuously. Installed a new seal to ensure proper seating, then filled and tested the tank to confirm correct, leak-free operation for a reliable toilet repair.

Addressed AC not cooling by replacing a failed capacitor and hard start kit, allowing the outdoor compressor to start properly and restore cold air throughout the home.

Arrived for the air conditioner repair to find the homeowner had already resolved the AC issue with another contractor. No further action was required.