HVAC and Plumbers Tuscola IL

Flushed line debris with nitrogen, then replaced the compressor, faulty TXV, and driers. Installed a suction drier to protect the new compressor, adjusted blower speed to resolve poor airflow, and recharged R-410A to restore cooling.

Performed HVAC maintenance and safety testing. Identified a failing furnace blower capacitor, damaged igniter, and corroded flame sensor. Found AC low on refrigerant, causing poor cooling. Provided estimates for repairs and system replacement.

Replaced 20x20x1 filter, cleaned condenser coils, and treated the condensate line. Diagnosed and repaired a burnt-out wire in the condenser and replaced the capacitor to restore reliable cooling performance and optimal HVAC efficiency.

Spring HVAC maintenance: Replaced 16x20x1 filters, cleaned condenser coils, and tested furnace and condenser capacitors. Verified proper airflow by checking static pressures and confirmed an efficient 16-degree temperature split.

Installed a new energy-efficient HVAC system to replace outdated equipment. Completed the furnace and air conditioning installation, connected a new thermostat, and verified system airflow for optimal heating and cooling performance.

Performed AC maintenance: changed filter, washed condenser, and cleared the drain line. Tested capacitor and contactor. Inspected residential plumbing, including sinks, toilets, and shut-off valves, identifying a plumbing issue.

Cleaned AC condensate line with solution and air to clear blockages. Inspected blower motor amp draw and checked for buildup. Verified refrigerant pressures and delta T to ensure optimal cooling performance and efficiency.

Performed AC service and diagnostics following a system shutdown. Identified history of voltage flickering and communication loss. Cycled power and verified the cooling system is operating properly with no active alerts.

Resolved a ceiling water leak by clearing a clogged HVAC condensate drain line and drain pan. Applied drain treatment tablets to prevent future clogs, verified proper cooling, and provided a replacement quote for the aging AC unit.

Cancelled onsite AC service visit after the homeowner confirmed the system was working properly, resolving the cooling issue without requiring a dispatch.

Completed bi-annual HVAC maintenance. Verified filter installation, inspected blower motor and evaporator coil, and ran static pressure tests. Cleaned exterior heat pump coils and checked refrigerant levels to ensure efficient AC service.

Replaced two 50-gallon electric water heaters and updated piping, including reconnecting the geothermal waterlines. Filled both tanks, bled air from the plumbing system, and tested thermostats to confirm leak-free operation.

Replaced furnace filter, inspected evaporator coil, and tested system pressures during HVAC maintenance. Inspected plumbing, verified water pressure (50 PSI), and provided a quote to repair two faulty master bathroom sink stoppers.

Conducted quality-assurance inspection on new furnace and air conditioning installation. Verified static pressures, gas pressure (3.40 inWC), and subcooling (11) to ensure energy-efficient heating and cooling service.

Diagnosed an AC not cooling issue and identified a faulty blower motor. Replaced the failed motor with a compatible unit to restore proper airflow and cooling system operation.

Evaluated trailer specifications to prepare a custom commercial plumbing proposal for installing sinks, a fresh water tank, and a gray water tank in a mobile beverage trailer.

Resolved a clogged main sewer backup. Rodded 120 ft downstream and 25 ft upstream to clear root intrusions and heavy sludge in the cast iron pipe. Performed a camera inspection to ensure the sewer line repair was fully clear.

Cleaned and tested AC components for cooling maintenance. Inspected plumbing fixtures, dye-tested toilets, checked shutoff valves, and performed water heater maintenance to ensure all systems are operating safely and efficiently.

Diagnosed AC not cooling and replaced a failed dual run capacitor. Tested the system's cooling performance to ensure proper airflow and temperature control.

Inspected basement flooding and drainage. Found the home's clay tile drain clear, but the city catch basin to the north is clogged with debris. Recommended contacting the city to clear their drains to resolve the water intrusion.

Cleared a clogged kitchen sink by removing the under-sink cleanout and running 50 feet of 5/16" drain cable to remove built-up food debris. Filled and drained the sink multiple times to ensure proper drainage.

Diagnosed AC not cooling due to a failed compressor. Replaced the warrantied compressor and 3/8” liquid drier, reclaimed refrigerant, pressure tested, evacuated, and charged the system with fresh R-410A to restore cooling.

Resolved flooding by performing storm drain cleaning. Vactored flooded catch basins and jetted lines to clear heavy sediment, mud, and rocks. Used camera inspection to diagnose issues and successfully cleared a blocked 10-inch line.

Conducted HVAC maintenance: replaced filter, cleaned condenser coils, treated drain, and noted weak capacitor. Flushed electric water heater, verified water pressure, and inspected sinks and toilets for leaks.

Replaced a failed 35/5 dual capacitor and noisy contactor to resolve an AC not cooling issue. Installed a compressor hard start kit to reduce start times and protect against heat damage, restoring efficient air conditioner cooling.